4 daily walk-around inspection, General, 4 daily walk-around inspection -5 – JLG 15SP Operator Manual User Manual

Page 25: General -5

Advertising
background image

SECTION 2 - USER RESPONSIBILITIES, MACHINE PREPARATION, AND INSPECTION

3120774

– JLG Lift –

2-5

2.4 DAILY WALK-AROUND INSPECTION

It is the user/operator’s responsibility to inspect the machine
before the start of each workday. It is recommended that each
user/operator inspect the machine before operation, even if the
machine has already been put into service under another user/
operator. This Daily Walk-Around Inspection is the preferred
method of inspection.

General

Begin the “Walk-Around Inspection” at item 1 listed following.
Continue around machine checking each item in sequence for the
conditions listed in the “Walk-Around Inspection Check list”.

TO AVOID INJURY DO NOT OPERATE MACHINE UNTIL ALL MALFUNCTIONS
HAVE BEEN CORRECTED. USE OF A MALFUNCTIONING MACHINE IS A
SAFETY VIOLATION.

TO AVOID POSSIBLE INJURY, BE SURE MACHINE POWER IS “OFF”
DURING “WALK-AROUND INSPECTION”.

NOTE: Do not overlook visual inspection of chassis underside.

Checking this area often results in discovery of conditions
which could cause extensive machine damage.

1. Wheels and Casters - Properly secured, wheels and

casters turn freely and are properly lubricated. Check for
any visible damage.

2. Floor Stop(s) - Properly secured to frame, no visible

damage (cracks, distortion, etc.) and is functioning
properly.

3. Base Frame - No visible damage; components properly

secured, no loose wires dangling below base; bubble
level in place and functioning properly.

4. Battery/Battery Charger Installation -

(DC Machines)

Proper battery electrolyte level (except

optional sealed AGM battery), cables secure, no dam-
age or corrosion.

5. Motor/Pump/Reservoir Unit - All properly secured, no

visible damage, no evidence of hydraulic leaks. Check
that hydraulic reservoir fluid level is filled to the "Fill to
Line" mark on the side of the reservoir.

6. Manual Descent Valve - (Located under the base frame

at the rear of the machine), properly secured, no loose
or missing parts, no visible damage.

7. Ground Controls - Key switch operable, no visible dam-

age; placards secure and legible; emergency stop
switch, no visible damage and properly set for opera-
tion.

Advertising
This manual is related to the following products: