JLG 15SP Operator Manual - Manual (Page 51)

SECTION 4 - MACHINE OPERATION
3120774 – JLG Lift – 4-17
4.9 RUG CARRIER ACCESSORY
(OPTION)
NOTE: The Rug Carrier Accessory is intended for use in hanging
and removal of rugs in hanging display racks only. Use
for any other purpose is not authorized by JLG.
General
The Rug Carrier Accessory consists of two pivoting arms mounted
to the platform left side rails. The pivoting arms are locked in the
plane of the platform side rail when not in use (the stowed posi-
tion). The arms are locked into position at approximately 90
degrees to the left side platform side rails when in use (the carry
position). The pivoting arms’ position can be changed by lifting
each arm to release the lock, rotating the arm, and lowering each
arm back into a locked position.
Pre-Start Inspection
Prior to use of the Rug Carrier accessory, check the following;
• Carrier arm mounting is secure to the platform railing, no
missing or damaged fasteners.
• The arm lock pins are in place and working properly.
Figure 4-8. SP Tie Down Pockets.
CORNER
TIE DOWN
POCKETS
CORNER
TIE DOWN
POCKETS