JLG 15ELI Operator Manual - Manual (Page 29)

SECTION 3 - USER RESPONSIBILITIES & MACHINE CONTROLS
3120778 – JLG Lift – 3-3
control, to close the valve (stop platform lowering)
release the valve knob (spring loaded).
1. HYDRAULIC RESERVOIR / CIRCUIT BREAKER /
FUSE (located inside ground control station hous-
ing)
The hydraulic reservoir is housed inside the ground
control station, the hydraulic oil level can be
checked through an access hole in the side of the
cover. Maintain an oil level to the "Fill to Line" indica-
tor on the side of the reservoir.
NOTE: Check hydraulic oil only when platform is completely
lowered and after cycling platform up/down a few
times.
A 20 amp reset type circuit breaker is located on the
cover of the electrical box on ELI-AC Models.
On ELI-DC Models, a 5 Amp fuse is located inside
the ground control station.
Platform Control Station
(See Figure 3-3.)
1. EMERGENCY STOP/SHUT-OFF Button.
An EMERGENCY STOP (RED) button is provided in
order to turn machine power on and off in the plat-
form and also to turn off machine power in the event
of an emergency. Power is on when the switch is in
the reset position (turned completely clockwise -
out). Power is off and all machine functions will stop,
when button is depressed.
2. FUNCTION ENABLE Button.
This (GREEN) button must be depressed simulta-
neously with either the UP or DOWN platform func-
tion buttons in order to operate the platform.
3. PLATFORM UP Button.
When depressed simultaneously with ENABLE but-
ton raises the platform to a higher level.
4. PLATFORM DOWN Button.
When depressed simultaneously with ENABLE but-
ton lowers the platform to a lower level.
1. Manual Descent Control Valve
2. Cut-Out at Rear of Base Frame
Figure 3-2. Manual Descent Control Valve Location -
Machines Built Since S/N- 0900019526.
1
2
Figure 3-3. Platform Control Station.
EMERGENCY STOP BUTTON
PLATFORM UP BUTTON
FUNCTION ENABLE BUTTON
PLATFORM DOWN BUTTON