Britax Roundabout - Manual (Page 10)

16 17
Installation: Rear-facing Installation: Rear-facing
Lap-Belt Installation
Figure A illustrates a typical rear-facing, lap-belt
installation.
When not in use, always store the LATCH connectors
in storage slots. See page 30.
Fully recline the child seat, then place it rear-
facing on vehicle seat.
See Recline Adjustment on page 30.
Lift the child seat cover and open rear-facing
lock-off farthest from where the vehicle belt
will be buckled (Fig. B).
Pull the vehicle belt out and pass it through
the closest rear-facing belt slot (Fig. C).
The vehicle belt can be routed over or under the
child seat cover.
Route the vehicle belt across the child seat
then through the second rear-facing belt slot.
IMPORTANT: The vehicle belt must rest behind the
child seat buckle.
Verify that the vehicle belt is not twisted and
buckle (Fig. D).
Push the child seat firmly into the vehicle
seat while removing slack from the vehicle belt.
Position the vehicle belt through the lock-off, tighten the belt,
then close the lock-off arm (Fig. E) and replace the cover.
Lock-off is properly closed when a positive click is heard.
To prevent breakage, never extend the lock-off arm beyond its normal
open position and always keep lock-off closed when not in use.
If your vehicle is equipped with an automatic locking retractor (ALR),
use of lock-offs is not required as long as the ALR is locked. Check your
vehicle owner’s manual to determine what type of retractor your vehicle
has, and how to lock the retractor.
•
•
1
•
2
3
•
4
5
6
7
•
•
•
Verify that the vehicle belt is tight and that
the child seat is secure.
When properly installed in the rear-facing position,
the back angle of the child seat should be 30º – 45º
from vertical (not to exceed 45º) when the car is
parked on a level surface (Fig. F).
If necessary, the proper recline angle can be
achieved by placing a rolled towel or pool noodle
in the crease of the vehicle seat to level the child
seat’s base.
Rear-facing installation can be improved by the use
of the Versa-Tether ® see pages 25 – 28.
The child seat is secure when it cannot be moved
more than one inch (2.5 cm) front-to-back or side-
to-side at the belt path.
8
•
•
•
•
Rear-Facing Rear-Facing A D
B E
C
WARNING! Do not raise the child
seat off the front edge of the vehicle
seat. This could cause your child seat not to
perform as intended.
Removal
If connected, disconnect the Versa-Tether ® from the tether
anchor.
Press the red release button on the vehicle belt buckle and pull
the vehicle buckle from the child seat belt path.
•
•
30–45º 0º
90º F