Bosch SGV45E03UC - Manual (Page 15)

1
2. Grasp the assembly as shown in figure 24 and turn it counter-
clockwise 1/4 turn.
3. lift out the assembly as shown in figure 25.
4. Carefully examine the assembly. If you find debris in the Large Object Trap, turn it
upside-down and gently tap it on a surface such as a countertop to dislodge and
remove the debris. flush the Cylinder filter clean by holding it under running water.
To Remove the Fine Filter:
1. Lift the Fine Filter from the dishwasher floor as shown in Figure
26 A and flush it clean by holding it under running water.
2. Remove the Micro Filter as shown in Figure 26 B and flush it clean by holding it under
running water.
To reinstall the filter system:
1. return the fine filter to its installed position.
2. place the large object trap/Cylinder filter assembly into its installed position in the
dishwasher floor.
3. turn the ring handle clockwise 1/4 turn until it is locked. the arrow
on the ring handle and the arrow on the fine filter should point to each other, as
shown by the circle in figure 27.
4. Gently pull the ring handle to ensure that the assembly is locked into place.
ATTENTION
To avoid possible diswasher damage, do not use harsh chemicals, abrasive cleaners,
scouring pads (metal or plastic), or abrasive cloths/paper towels to clean your dish-
washer’s exterior door panel. Your dishwasher’s exterior door panel can be damaged
by doing so.
Figure 
Figure 
Figure 
large object trap/Cylinder filter
Fine
Filter
Micro
Filter
To close - turn clockwise.
A
B