BURY CP 1000 CarPhone USER Manual - Manual (Page 24)

24
Operating guidelines
Audio
In this area you have the possibility to change the audio settings of the
BURY CP 1000 CarPhone.
The BURY CP 1000 CarPhone is sold with four Ringtones from which
you can respectively select one. With „NEXT“ or „PREVIOUS“ you
can navigate in the list. With „SELECT“ the ring tone is selected.
The volume level for the voice feedback and the selected ring tone can
be set in an additional sub menu. The volume of the beeper that gives
the signals for speed control and for the hazardous zones can also be
set here in the same way. Available as voice commands are „LOUD-
ER“, „LESS“, „MAXIMUM“, „MINIMUM“ and „ACCEPT“.
For some radios it may cause problems if the BURY CP 1000 CarPhone
starts with voice response immediately after the mute signal. Some
radios need some time for a corresponding activation and reaction to
the mute signal. This will be indicated to you through the fact that you
don’t hear the signal tone at the start of the voice control. To avoid this
effect, you can enter a maximum delay of up to three seconds in the
„MUTE DELAY“ menu item. It is only after this time has elapsed that
the BURY CP 1000 CarPhone begins with the voice feedback.
Display
This menu point makes it possible for you to adjust the display in
a range of different ways.
In order to avoid the blinding effect especially when driving at night,
you can activate the Sleep mode. This causes the display to shut off
after either 15, 30 or 60 seconds. With an incoming call, the BURY CP
1000 CarPhone activates the display automatically.
In the Illumination menu item you can change the intensity of the
light diodes in the display. As voice commands „MORE“, „LESS“,
„MINIMUM“ or „MAXIMUM“ are available. The confirmation follows
with „SELECT“.
To be able to read the contents of the display optimally during different
light conditions, in the next menu item, Day/Night mode, you are
able to invert the display.
Audio
Ringtones
Play
Select
Volume
Speech
Ringtone
Mute delay
Display
Sleep mode
Illumination
Day mode
Night mode
Auto mode
Day/Night mode