Starting hard to start engine, Cs-370 operation – Echo CS-370 Serial C08011001001 - C08011999999 User Manual

Page 21

Advertising
background image

CS-370

OPERATION

© 12/2013 ECHO Inc.

X7503251407

21

2. Fill the fuel tank with fuel mixture. Do not over fill.

3. Fill the chain oil tank with lubricant. Do not over fill.

4. Move ignition switch (A) to “RUN” position.

5. Push purge pump (B) 3 to 4 times or until fuel is visible in

purge pump.

6. Pull choke control knob all the way out (Closed Choke)

position.

7. Securely hold the chain saw and pull starter handle several

times until first starting sound.

8. Push choke control knob all the way in.

9. Pull starter handle to start the engine.

Note: Do not pull starter rope out to the maximum possible

position.

Do not allow recoil handle to snap back against the
casing.

Note: If engine does not start after 5 pulls, repeat instructions.

Note: Do not increase engine speed while chain brake is locked.

Severe brake damage will result.

Starting Hard to Start Engine

Make sure the bar and chain are free from any obstruction
when starting the chain saw.

1. Move chain brake lever fully forward to lock chain brake

before starting.

2. Press throttle trigger lockout (B) down while grasping throttle

trigger and push in throttle lock button (C).

3. Move ignition switch (A) to “RUN” position.

4. Securely hold the chain saw as shown and pull starter

handle.

5. When engine starts, immediately squeeze and then release throttle trigger, to release throttle lock

button.

A

B

Chain brake

Advertising