Preparation for use, Kick guard, Guide bar and saw chain installation/removal – Echo CS-271T C21112001001 - C21112999999 User Manual

Page 12

Advertising
background image

10

CS-271T

PREPARATION FOR USE

WARNING

Saw chain is sharp! Always wear gloves
when handling assembly, otherwise serious
personal injury may result.

KICK GUARD

®

TO BAR

INSTRUCTIONS

Tools Needed: Two 11 mm (7/16 in.) Wrenches.
For saws with Kick Guard

®

P/N 2893201 and

Symmetrical Low-Kick type (Double Guard)
guide bars.

1. Install bolt (A) in

rear hole (B) of Kick Guard

®

and through front hole (C) in guide bar.

2. IMPORTANT: Dimple (D) in Kick Guard

®

must

engage recess (E) in guide bar.

3. Tighten nut (F) and bolt (A) using 11 mm (7/16

in.) wrenches until snug. Make certain Kick
Guard

®

is flush against guide bar.

4. Tighten nut (F) 1/8 additional turn.

5. Check to make certain Kick Guard

®

is tight on

guide bar.

GUIDE BAR AND SAW CHAIN
INSTALLATION/REMOVAL

NOTICE

• Move the chain brake lever (Front hand guard)

fully rearward to remove or install the clutch
cover to chain saw.

1. Remove spark plug lead. (See page 25)

2. Remove the clutch cover nut and remove clutch

cover.

3. Remove bar and saw chain if necessary. See

“Maintenance and Care” section for guide bar/
saw chain maintenance procedures.

Bolt (A)

Dimple (D)

Recess (E)

Front hole (C)

Rear hole (B)

Nut (F)

Guide bar

Kick Guard

®

Clutch cover

Brake lever
(Front hand guard)

A nut

Advertising
This manual is related to the following products: