Echo CH611DH Instruction v.9 - Manual (Page 14)

Instruction Sheet
14
CLICK ONE - (ON LEFT SIDE
NAVIGATION BAR)
We have now moved to the
SERVICE tab on the left.
CLICK TWO -
CP_EngHrResetCount is how
many times the code for changing
the oil has been reset. This will
only be relevant on controllers with
the REV207 and older. We have
removed the oil change code to
simplify the codes.
CP_EngHRReset_3 is when the
control bar has successfully reset
the engine oil reset.
CP_EnghrResetINEnable this
will turn on within the time frame
you have to reset the time on the
engine oil code.
CP_model (This tab is not
available on the dealer or
distributor version).
CLICK THREE-
Blade_Run_Minutes is the time
(in minutes) the sensor at the disc
has seen RPM.
Blade_Run_Hours is the time (in
Hours) the sensor at the disc has
seen RPM.
Engine_Run_Minutes is the time
(in minutes) the key switch has
been turned on.
Engine_Run_Hours is the time
(in Hours) the key switch has been
turned on.
CLICK FOUR-
These boxes are not used at this
time.
CLICK ONE