Echo CH8670H Instruction v.5 - Manual (Page 2)

Instruction Sheet 2
Install the tri-colored LED in the lower left hole of the controller enclosure by unscrewing the LED hex nut, pushing 1.
the LED into the enclosure from the front, and securing it with the hex nut.
Bolt the Plus 1 controller into the controller enclosure as shown below with four (4) rubber bumpers (two behind the 2.
controller and two on top).
INSTALL PLUS 1 CONTROLLER
RUBBER
BUMPERS
1-1/4”
HEX BOLT
2-1/4”
HEX BOLT
PLUS 1
CONTROLLER
CONTROLLER
ENCLOSURE
CIRCUIT
BREAKER
TRI-COLOR
LED