Echo CH611DH Owners Manual v.2 - Manual (Page 10)

6 6 INCH CHIPPER
Section
If any bolts or nuts are dropped in the machine, be
sure to remove them before starting the machine.
WaRNING
aSSEmbLY
2.1 aTTaCH TRaILER WHEELS
2.3 aTTaCH TRaILER HITCH
Where applicable.
Remove the chipper from its shipping crate. Place the 1.
unit on a level surface before attempting to assemble
it. See the torque chart in the back of the manual for
tightening torque of bolts and screws.
Raise the trailer several inches from the ground with
2.
a hoist or jack. Support the chipper securely.
lift one wheel to a hub and align the wheel lug holes
3.
with the hub lug bolts. Thread the lug nuts (found in
the parts kit) onto lug bolts and tighten the lug nuts to
75 ft. lbs. Follow a star pattern when tightening the
lug nuts. Repeat this step for the remaining wheel.
Where applicable.
Attach the ball coupler to the hitch weldment using 1.
the provided 1/2” x 4” bolts and 1/2” washers and 1/2”
nuts. Tighten to proper torque.
Slide the hitch weldment into the chipper trailer, back
2.
to the 1/2” mounting holes.
Connect the hitch weldment to the frame using the two
3.
1/2” x 4-1/2” bolts, 1/2” washers and 1/2” nuts. Tighten
to proper torque.
Check to make sure the tongue jack and safety chains
4.
(non-Euro only) are installed correctly.
2
Euro hitch
Non-Euro hitch
2.2 INSTaLL REaR STabILIzER
The rear stabilizer is installed by sliding the stabilizer into
the trailer support guide on the rear of the chipper frame.
The stabilizer is secured and adjusted with the provided
snap pin.
Rear stabilizer and snap pin