Echo 76624 Owners Manual v.4 - Manual (Page 22)

18 6 INCH CHIPPER
SERVICE & MAINTENANCE
BEFORE INSPECTINg OR SERVICINg ANy PART OF THIS MACHINE, SHuT OFF POWER SOuRCE,
DISENgAgE THE HyDRAulICS, AND MAKE SuRE All MOVINg PARTS HAVE COME TO A COMPlETE STOP.
WaRNING
5.6 LubRICaTIoN
Grease zerk on bearing assembly (top). Two grease zerks are on
the drive shaft. The one on the left is located under the access cover
(middle). One zerk is on the discharge chute base (bottom).
5.7 CLEaRING a pLuGGED RoToR
FEED
ROLLER
JACK
LOCK PIN
STORAGE
POSITION
SUPPORT
BRACKET
LOCK PIN
POSITION
CHECK
VALVE
lubricate the machine periodically with a lithium-based
grease. Extreme working conditions will require more
frequent greasing.
grease the following points every 50-100 hours of
operating time:
Feeding too large or too much material at once may plug
the chipper. To clear a plugged disk, proceed as follows:
lift the engagement handle and turn off engine key 1.
switch. Allow all moving parts to come to a complete
stop.
Remove the two 3/8” retaining bolts holding the access
2.
cover to the chipper frame and lift up access cover.
Remove the lock pin from storage position (see
3.
below).
Turn check valve clockwise to engage the jack pump.
4.
Pump the handle to raise the feed roller until the lock pin 5.
position aligns with one of the support bracket holes.
Secure the position by putting the lock pin through the
6.
support bracket and lock pin position.
Clean the debris away from the chipper disk. Turn the
7.
disk by hand to be sure it is free to rotate. Be careful
to avoid the chipper blades when cleaning out the
debris.
Remove the lock pin and put it back in storage
8.
position. lEAVINg THE lOCK PIN IN ANy OTHER
POSITION MAy INTERFERE WITH FEED ROllER
OPERATION.
turn the check valve counterclockwise to disengage
9.
the pump and lower the jack.
Close access cover and replace bolts.
10.
Start the engine. Lower the engagement handle 11.
when engine is running to engage drive belt. Resume
operation at 1/4 throttle.
Do not over grease bearings. Overfilling can lead to
excessive heat and/or unseating of the seals. Add
grease slowly and under light pressure. Whenever
possible, rotate bearing slowly while lubricating.
NoTE
Polyurea and lithium-based greases are not compatible.
Mixing the two grease types may lead to premature failure.
ImpoRTaNT