Echo 76628S - Manual (Page 28)

PN 14295-00 R 26
SERVICE & MAINTENANCE
BEFORE INSPECTINg OR SERVICINg ANY PART OF THIS MACHINE, SHUT OFF POWER SOURCE,
DISENgAgE THE HYDRAULICS, OPEN SHIELD AND MAKE SURE ALL MOVINg PARTS HAVE COME TO A COMPLETE STOP.
WarnInG
5.8 Coolant (DIesel)
5.9 hyD reservoIr FluID
Fig. #28 Shredder knive assembly diagram
the diesel kubota is tested before shipping. In order to test
the equipment the fluid levels are filled. However, before
starting the machine, and every time the engine is started
thereafter, be sure to check the coolant level. If the level
is low add fluid.
To add fluid follow the procedure below:
1. Make sure the coolant isn’t hot.
2. Open the radiator cap pictured in Fig #28.
3. Check level and add if necessary. use a 50/50 mixture
of antifreeze and water.
Fig. # 31, Diesel coolant level
the chippers are tested before shipping. In order to test
the equipment the fluid levels are filled. However, check
the fluid levels before initial operation and add if necessary
(see the assembly section). Always check levels before
each use. to check levels look at the side of the hydraulic
oil container and make sure the fluid level falls between
the marks. If necessary add oil.
on the kubota models the hydraulic tank is located next to
the fuel tank. A cutout exists to check the fluid level.
Premium hydraulic fluids containing high quality rust,
oxidation and foam inhibitors are required. these include
premium turbine oils, aPI Cd engine oils per SaE j183,
M2C33F or g automatic transmission fluids meeting Allison
C-3 or Caterpillar to-2, and certain specialty agricultural
tractor fluids.
Fig. # 32, Hydraulic reservoir