Echo LS21 Owners Manual v.2 - Manual (Page 6)

2 LOG SPLITTER
SAFETY
1.4 oPeraTIon saFeTY
1. This machine should be used for splitting wood only,
do not use it for any other purpose.
2. Allow only one (1) person to load and operate the log
splitter. If a helper is assisting in loading logs, never
activate the control until the helper is a minimum of 10
feet away from the machine.
3. Always operate the log splitter from the operator zones
specified in Section 4.4.
4. Do not use any body part, other than your hand, to
operate the controls.
5. Keep hands and feet out of splitting area while machine
is operating to avoid serious personal injury. Stop
and allow machine to come to a complete stop before
clearing obstructions.
6. Set up your work site so you are not endangering traffic
and the public. Take great care to provide adequate
warnings.
7. Never operate the machine on slippery, wet, muddy, or
icy surfaces. The location you choose should be solid,
level, dry, and free from any tall grass, brush, or other
interferences.
8. Always block machine wheels to prevent unintended
movement and lock in either horizontal or vertical
position.
9. Ensure the control lever is in the neutral detent position
before starting the machine.
10. Keep the machine clear of debris and other
accumulations. Immediately remove split wood from
around the machine so you do not stumble over it.
11. During operation, hydraulic log splitters develop high
fluid pressures. Fluid escaping through a pin hole
opening can penetrate your skin and cause blood
poisoning, gangrene, or death. Keep in mind the
following instructions at all times:
a. Do not check for leaks with your hand.
b. Do not operate machine with frayed, kinked,
cracked, or damaged hoses, fittings, or tubing.
c. Stop the engine and relieve hydraulic system.
pressure before changing or adjusting fittings,
hoses, tubing, or other system components.
d. Do not adjust the pressure settings of the pump
or valve.
12. leaks can be detected by passing cardboard or wood,
while wearing protective gloves and safety glasses,
over the suspected area. look for discoloration of the
cardboard or wood.
13. If injured by escaping fluid, see a doctor immediately.
Serious infection or reaction can develop if proper
medical treatment is not administered immediately.
14. Do not attempt to split two logs with one positioned on
top of the other.
15. Check the logs before splitting. Ensure there are no
foreign materials, such as nails, present in the wood.
16. Do not attempt to split wood across the grain.
17. Always make sure that both ends of the log you are
splitting are cut as square as possible. This will prevent
the log from sliding out of position while under pressure.
logs should be 24 inches or shorter in length.
18. Do not load the log splitter while the splitting wedge
is moving.
19. Hold the log by the sides when you are positioning it
into the log splitter. Do not hold the log by the ends.
20. Always keep your fingers away from any cracks that
open in the log during the splitting operation.
7. Do not operate this equipment in the vicinity of
bystanders. Keep the area of operation clear of all
persons, particularly small children. It is recommended
that bystanders keep at least 50 feet (15 meters) away
from the area of operation.
8. Do not allow children to operate this equipment. Allow
only adults to operate the log splitter. No one under the
age of 18 should be allowed to operate the log splitter.
9. use only in daylight or good artificial light.
10. Do not run this equipment in an enclosed area. Engine
exhaust contains carbon monoxide gas, a deadly
poison that is odorless, colorless and tasteless. Do not
operate this equipment in or near buildings, windows
or air conditioners.
11. Always use an approved fuel container. Do not remove
gas cap or add fuel when engine is running. Add fuel
to a cool engine only.
12. Do not fill fuel tank indoors. Keep open flames, sparks,
smoking materials and other sources of combustion
away from fuel.
13. Do not operate machine without shields in place.
Failure to do so may cause serious injury or death.
14. Keep all guards, deflectors, and shields in good working
condition.
15. Before inspecting or servicing any part of this machine,
shut off the machine and make sure all moving parts
have come to a complete stop. Disconnect the spark
plug.
16. Check that all screws, nuts, bolts, and other fasteners
are secured, tightened and in proper working condition
before starting the machine.
17. Do not transport or move machine while it is operating
or running.