Echo LS21 Instruction v.3 - Manual (Page 5)

Instruction Sheet 5
22. Hook the spring between the lever bottom sheet and
the mount angle. On the quick split kit adjustment
may be necessary in order to achieve idle and full
throttle. Make adjustments at points (a) and (B) to
attain desired RPM settings. Ensure that the screw at
point (B) is not overtightened to the extent that the
cable stop will no longer pivot.
Figure 19. Quick Split
Figure 20. Throttle Down
Figure 21. Installation of new cast wedge bottom plate(B)
OPERATION
QUICk SPLIT
1. Set the point to which the anvil will return by pulling the
ball out and adjusting the slider plate.
2. Move handle to split log.
3. after the log is split, push handle back and release. The
anvil will go back to the set point and then stop. The
engine will automatically throttle down.
THROTTLE DOWN
1. Move handle to split log.
2. after the log is split, push handle back and release. The
anvil will go back to its original location and then stop.
The engine will automatically throttle down.
A
B
23. Remove the existing bottom wedge plate (a) as
shown in Figure 21, by removing the 1/2 nuts and
washers from the three 1/2 x 1-3/4" bolts securing it
to the wedge.
24. Install the new bottom wedge plate (B) that is supplied
in the Quick Split kit by reinstalling the bolts and
hardware, removed in step 23, and tighten securely.