ADS-TEC OPC7000 User Manual
Page 3
Quick Start Guide OPC7000 series mounting/commissioning
3
110523_
Q
UICK
S
TART
GUIDE
OPC7000_EN_DZ-HAND-91044-1
V1.0
© ads-tec GmbH • Raiffeisenstr.14 • D-70771 Leinfelden-Echterdingen; Germany
1. OPC7022 enclosure installation
OPC7022
1.Remove the screws from all Quick snap tensioners.
2. Screw the provided M3x30 I/A threaded bolts one each into all of the Quick
snap tensioners.
Attention:
For a correct device installation, the opened tensioners
must be pushed into the panel! Refer to the picture.
If you don't fully observe these installation instructions,
the device can no longer be removed from the enclosure!
3. Insert the OPC7022 into the enclosure.
4. Fix the OPC7022 device in position by installing the provided screws (M3x8
Tx10) at the enclosure from the outside.
5. The drilled VESA holes are closed with plugs when the device is delivered.
These plugs must be removed before installation if you go for the VESA
installation option. Keep any unused holes closed with the provided plugs.