4 mounting procedure – ADS-TEC IPC1100/1200 User Manual
Page 13
Industrial PCs IPC1100/1200
© ads-tec GmbH • Raiffeisenstr.14 • 70771 Leinfelden-Echterdingen
13
3.4
M
OUNTING PROCEDURE
•
Use the drilling template to drill holes according the mounting illustration in the
control panel with the specified threading.
•
Insert the upper screws half way into the control panel and hang the device on the
mounting links.
•
Tighten the screws and insert the rest of the screws.
Note:
The device is connected to the power supply using a lead out terminal with a screw
connection. A ground connection does not have to be made, because the grounding
conductor of the device plug or supply connection serves this purpose. If additional
grounding conductors are attached to a grounding screw, a wire diameter of at least 2.5
mm² is specified.
Pos : 16 /D atent ec hni k/Stec kkar tenei nbau/Hi nweis vor dem Einbau/Hi nweis vor dem Einbau f ür IPC 1100 @ 0\ mod_1158843763624_681. doc @ 775 @