AIM Sports Fiber Optic Tri-Illuminated Scopes - Manual (Page 15)

19 12
2. With the sight able to be moved, position the sight forward or backwards
until the sight is in the desired position. Once it is “zeroed,” re-tighten
the screw so that it will not move. Do not overtighten.
*NOTE*
The rear sight assembly is held onto the scope eyepiece using a band
with two hex screws. The sight is not zeroed from the factory and it may
be necessary to rotate the rear sight assembly on the eyepiece in order to
correctly align it with the front sight. If it needs to be aligned, use the allen
wrench provided with your scope to slightly loosen the hex screws, move
the sight into the desired position, and then re-tighten the screws.
CHANGING SCOPE BATTERY
All AIM Illuminated Reticle scopes use a 3-volt lithium photo battery.
1. Remove the battery cover by grasping its edge (located around the
top of the illumination dial) and twisting the cover counterclockwise
while holding the sides of the illumination dial to keep the entire dial
from turning.
2. Remove the old battery from its position in the center of the dial.
The battery for the AIM Illuminated Reticle is located
inside the control dial and can be changed without tools.