AiM LCU-One CAN for MXL/EVO3 - Manual (Page 13)

LCU-ONE CAN connected to MXL and EVO3
User Manual
Release 1.05
4
Chapter 5 – Data Visualisation on MXL/EVO3
9
5.1 – Data Visualisation on MXL
Lambda channels visualisation on MXL
works exactly like the visualisation of any
other MXL channel. To switch from one
page to the other use “MEM/View”.
Refer to MXL user manual for further
information. In the right figure lambda
value is 0.95 and assigned Short Name
is LAM.
Switching MXL on, Lambda controller is recognised at start-up and probe Warm-Up
procedure starts. During this period, the controller takes the probe to its working
temperature (until around 780 °C – 1436 °F).
During warm-up (around 20-30 seconds), displayed lambda value is 1.00.
When the probe is 100% working, displayed value turns, with the engine off, into 1.60
(free air value).
1 0
5.2 – Data Visualisation on EVO3
Lambda channels visualisation on EVO3
works exactly as the visualisation of any
other EVO3 channel and is thereby
possible only if the logger is connected to
a display.
The only displays that show Lambda
value are MyChron3 Dash and Formula
Steering wheel
. In the right figure
Lambda value is 0.95 and the field is
labelled as “λ”
Switching EVO3 on, Lambda controller is recognised at start up and probe Warm-Up
procedure starts. During this period the controller takes the probe to its working
temperature (until around 780 °C – 1436 °F).
During warm-up (around 20-30 seconds), displayed lambda value is 1.00.
When the probe is 100% working, displayed value turns, with the engine off, into 1.60
(free air value).
www.aim-sportline.com 12