AiM LCU-One Analog ver 1.02 - Manual (Page 12)

LCU-ONE Analog
User Manual
Release 1.02
1 2
3.2.3 – The keyboard
On the left of the window are some buttons:
• “Restore default lambda settings”: allows the user to restore default settings
on LCU-ONE Analog.
• “Transmit lambda configuration”: allows the user to transmit the configuration
to the device
• “Read Lambda configuration”: reads the configuration from the connected
device
• “UpgradeFirmware”: allows the user to upgrade the firmware of its device.
Bottom central are these buttons:
• “Save Lambda settings”: allows the user to export Lambda configuration
• “Load lambda settings”: allows the user to import a Lambda configuration and
transmit it to the device
In the lower part of the window are thrre buttons:
• “Select language”: allows the user to change the language
• “OK”: allows the user to save the set parameters
• “Exit”: allows the user to quit discarding changes.
1 0
3.2.4 – Informative panels
On top left of the software main window a series of panels shows the characteristics of
the LCU-ONE Analog connected to the PC. These panels are different depending if the
device is connected or not.
Here below you see (left) the panels with the controller connected to the Pc and (right)
the same panels with the controller not connected to the PC.
• Connected to: PC serial port
• Device type: LCU-ONE Analog
(controller has been recognised)
• Device ID number: univocal serial
number of the device
• Firmware Version: firmware version
installed on the device.
If LCU-ONE Analog is not
correctly connected to the Pc or if
it is not connected at all, the
system shows a “not connected”
message and all information
concerning the controller are set
on N.D. (Not available)
www.aim-sportline.com 11