AirLive Ether-GSH8TW v2 - Manual (Page 33)

2.3 Maintenance
2.3.1 Warm Reboot
Choose and click command manual, diagram will be shown like below. User can press Yes or No.
Warm Reboot
Are you sure you want to perform a warm reboot?
Yes No
2.3.2 Factory Default
Choose and click command manual, diagram will be shown like below. User can press Yes or No
Factory Default
Are you sure to reset configurations to factory default?
Yes No
2.3.3 Firmware Update
Choose and click command manual, diagram will be shown, and then direct the location of the file that is to be
updated, then press “upload”. If successful, it will be shown below.
Software successfully loaded
Do you want to activate new software?
Yes No
Press “yes” then you get new code to execute . However, after activating the new code, it is better to press
“ reset button ” at front panel so that the new default setting will be also updated, because different version
code is sometimes with different initial default setting .
2.3.4 Config File
Choose and click command manual, diagram will be shown, and then direct the location of the file that is to be
backup, give a name, then press “Backup”.
AirLive Ether-GSHTW v2 / 8TW+v2 User’s Manual
30