AirLive MU-7000AVs - Manual (Page 29)

6. Network Hard Disk (AirLive NDAS Mode)
5. Move a NDAS Device from the left window to the right window by first selecting a NDAS Device
from the left window and then clicking the 'Add' button.
6. Repeat the above step for the rest for the NDAS Device you want to Bind and click Finish.
7. Two warning messages will appear.
- Once NDAS Devices are bound, all of the data will be lost. Click Yes to continue.
- The new bound NDAS Devices must be mounted and formatted before it can be used. Click Finish.
- Your NDAS Devices should now be bound
8. Go to the NDAS Device Management and Mount the Bound NDAS Devices.
- To do so, select any one of the Bound NDAS Device and select Mount (Read-Only) or Mount
(Read/Write) .
9. Found New Hardware Wizard may appear. Click Next and proceed in finishing the wizard.
10. Before Bound NDAS Device can be used, it must be formatted.
6.5.2 Unbind
You can unbind one or all of the NDAS Devices from a bound group.
Unbind All
1. Go to NDAS Device Management and select a Bound NDAS Device you want to Unbind.
2. Unmount the NDAS Device by clicking on Unmount.
Note : If the bound NDAS Device is in use, a warning message will appear.
Make sure that no programs are using the NDAS Device and try again.
3. After you have unmounted the NDAS Devices, go to NDAS Bind Management.
4. From the NDAS Bind Management, select the Bound NDAS Device you have just unmounted. Click
the Unbind button
23
AirLive MU-7000AV User’s Manual