AirLive POE-200HD - Manual (Page 29)

5. Administrating the Device
AirLive POE-200HD User’s Manual
25
vailable from the other (WAN) side of a NAT router. With NAT traversal properly configured,
traffic to an external HTTP port in the NAT router will be forwarded to the device.
PnP:
ble the UPnP service here.
riendly Name:
e.
hen enabled, the device will attempt to configure port mapping in a NAT router on your
UPnP™. Note that UPnP™ must be enabled in the NAT router first.
ort Range:
n in NAT router.
versal is
onfigured successfully, user can use this IP address and port to access this device. The
xternal IP address is not shown in case NAT traversal function is failed.
In addition, this device also provides UPnP IGD function for NAT traversal easily. Use NAT
traversal when your device is located on an intranet (LAN) and you wish to make it
a
all HTTP
U
To enable or disa
F
Shows the friendly name of this device her
UPnP NAT Traversal
W
network, using
P
The port range will ope
External IP address:
Show the IP address and port for WAN access through Internet. If NAT tra
c
e