AirLive WN-151ARM - Manual (Page 27)

AirLive WN-151ARM User’s Manual 27
3.2 LAN Screen
Use the LAN hyperlink on the main menu to reach the LAN screen. An example screen is shown below.
Figure 1: LAN Screen
LAN Screen
TCP/IP
IP Address IP address for the WN-151ARM, as seen from the local LAN. Use the default
value unless the address is already in use or your LAN is using a different IP
address range. In the latter case, enter an unused IP Address from within the
range used by your LAN.
Subnet
Mask
The default value 255.255.255.0 is standard for small (class "C") networks. For
other networks, use the Subnet Mask for the LAN segment to which the
WN-151ARM is attached (the same value as the PCs on that LAN segment).
DHCP
Server
• If enabled, the WN-151ARM will allocate IP Addresses to PCs (DHCP
clients) on your LAN when they start up. The default (and recommended)
value is Enabled.
• If you are already using a DHCP Server, this setting must be disabled, and
the existing DHCP server must be re-configured to treat the WN-151ARM
as the default Gateway. See the following section for further details.
• The
Start IP Address and Finish IP Address fields set the values used by
the DHCP server when allocating IP Addresses to DHCP clients. This
range also determines the number of DHCP clients supported. Enter the
desired value for the Lease Time, which should be between 1 and 7.
See the following section for further details on using DHCP.