AirLive WT-2000AP - Manual (Page 8)

AirLive WT-2000AP User ’s Manual 6
2.2 Procedure for Hardware Installation
2. Decide where to place your Wireless Access Point
You can place your Wireless Access Point on a desk or other flat surface, or you can mount it on a
wall. For optimal performance, place your Wireless Access Point in the center of your office (or your
home) in a location that is away from any potential source of interference, such as a metal wall or
microwave oven. This location must be close to power and network connection.
2. Setup LAN connection
a. Wired LAN connection: connects an Ethernet cable from your computer’s Ethernet port to one of
the LAN ports of this product.
b. Wireless LAN connection: locate this product at a proper position to gain the best transmit
performance.
Figure 2-3 Setup of WLAN and LAN connections for this product.
4. Power on
Connecting the power cord to power inlet and turning the power switch on, this product will
automatically enter the self-test phase. When it is in the self-test phase, the indicators M1 will be
lighted ON for about 10 seconds, and then M1 will be flashed 3 times to indicate that the self-test
operation has finished. Finally, the M1 will be continuously flashed once per second to indicate that
this product is in normal operation.