Allen&Heath iDR D-In - Manual (Page 4)

4 IDR D-in/out User Guide AP6636
Expanded multiple iDR system
This diagram
shows an iDR system with two iDR-8 units and both expanders
fitted. A system could also be created with iDR-4 units or a mix
of iDR4 and iDR-8 units. Note that the digital or analogue
expanders may be used, but only one input and one output
expander may be added per system. DR-Link is only required
to connect to the expanders, not between the main units.
Make sure you connect DR-Link to the iDR associated with
each expander. Make sure you plug into the correct DR-Link
socket. In this case do not daisy chain DR-Link from one
expander to the other.
Use CAT5 STP cable. Maximum cable length is 250 metres.
Maximum audio matrix is 16x16. The audio link cable carries 8
channels. This can provide a distributed system with 8
common channels and 8 local channels at each unit.
Working with iDR System Manager
The online
Editor recognises any expanders connected. If you are
working offline then a simulation of the expanders is provided.
This is the same for either the analogue or digital output
expander. If you want to simulate a digital input expander then
select this from the File / Preferences / Expander Options
menu. When choosing a digital input as a channel Source you
can select either the AES3 or the SPDIF connection. The
digital input selection is also available as a parameter which
can be stored and recalled in the presets.
For further information refer to the Allen & Heath web site or
contact Technical Support in your area.
www.allen-heath.com
Inputs x8
4x pairs AES3 and SPDIF
Sample rate conversion
Select using iDR System Manager
Outputs x8
4 pairs AES3 and SPDIF
Both formats available simultaneously
Expander Input / Output Port
Proprietary 8 channel digital audio
Connects to iDR-4 or iDR-8 main unit
CAT5 STP cable up to 250 metres (825 feet)
DR-Link Port
Serial control of iDR expander units
Proprietary Allen & Heath control protocol
IN and OUT ports provided to allow daisy
chaining through multiple units
CAT5 STP cable up to 250 metres (825 feet)
Status LEDs
Power –mains power on
Link – DR-Link control communication
Lock –audio communication
Soft LEDs
Assignable by the installer
iDR D-in 8x front panel indicators
iDR D-out 8x front panel indicators
3-colour – green, yellow, red, off
Function 3-colour signal meters
Mute on/off (red)
Static patch related (one of 3 colours)
Power Supply
Universal mains input switched mode design
IEC 3pin socket
Country dependent mains lead supplied
Rear panel power on/off switch
AC mains input 100-240V AC 50/60Hz
25VA max
Fuse T500mAL 20mm
Mechanical
1U rack 483 x 232 x 44mm
19” x 9.1” x 1.7”
Desk 443 x 232 x 48mm
17.4” x 9.1” 1.9”
Weight 3.5kg, 7.7lbs
IN OUT
AU
DI
O
12 LR 11 LR 10 LR 9 LR IN
DR-LINK
DR
-L
IN
K
IN OUT
OUT 12 LR 11 LR 10 LR 9 LR
DR-LINK
IN
OUT
IN
iDR D-out
iDR
8 7 6 5 4 3 2 1
8 7 6 5 4 3 2 1
IN
OUT
IN
OUT
iDR
8 7 6 5 4 3 2 1
8 7 6 5 4 3 2 1
IN
OUT
OUT
DR-L
IN
K
iDR D-in
AU
DIO