Allen&Heath XONE S2 - Manual (Page 32)

Allen & Heath 32 XONE:S2 User
REPLACING THE CROSSFADER / FACE PLATE
Replacing the Crossfader
Use a medium size cross-point screwdriver to undo and remove the two outer screws on the
crossfader plate. Do not remove the inner screws. Carefully pull the crossfader assembly away
from the front panel. Unplug the cable from the old crossfader and plug in the new assembly.
Check that the connector is correctly aligned and pushed on. Replace the assembly making sure the
cable faces the left side of the console. Refit the screws and test operation.
Standard Alpha Crossfader Part Number— 003-724
Penny and Giles Crossfader Option Part number— 003-726 JIT
Replacing the Fader Plate
To convert the Xone:S2 from linear faders to rotary or from rotary to linear, undo the four cross-
point screws and carefully pull fader plate away from the front panel. Gently pull the wire harness
of the fader PCB (be very careful not to pull the other end of the harness off the slave PCB).
Replacement is the reversal.
Rotary Fader Plate - Xone:S2—Rotary
Linear Fader Plate - Xone:S2—Linear