Allen&Heath ZED-10FX - Manual (Page 20)

Allen & Heath 20 ZED-10FX User Guide
STEREO INPUT CHANNEL 1
Right
Left
+10
+6
Right
Left
-15 +15
-15 +15
Record
0
+15
0
5
L R
+6
0
Listen
BAL
AUX
FX
LF
HF
0 LEVEL
-15
FX send
This controls the level of signal that is sent to the effects
processor from the stereo channel. The signal is post-level
which means it is affected by the channel Level control (so
it stays in proportion to the signal going to Mix) and the
send control has 6dB gain fully clockwise.
There is no master level control for the FX bus.
AUX send
Controls the level of signal sent to the Auxiliary output
from the stereo channel. The signal is sourced pre-Level so
is independent of the level being sent to the main L-R Mix.
The send control has +6dB gain fully clockwise and unlike
the FX bus, there is a master level control for the Aux
output.
Balance
The balance control adjusts the relative level between the
left and right stereo signals as they are sent to the stereo
buses and subsequently the main stereo outputs. Set to the
mid position, equal amounts of signal are fed to left and
right, with Bal set to L, none is sent to the Right bus.
LEVEL
The rotary Level or fader controls the amount of signal to
the left & right buses, Record bus and to the FX send con-
trol. There is 10dB of gain fully clockwise and the unity
gain position is marked by “0”.
Record
Switches the channel signal to a separate stereo bus called
Record. The Bal and Level controls affect the Record signal
and the channel Mix L-R signal remains unaffected by this
switch.
Listen
Switches the channel signal to the headphones or monitor
output circuit for checking the channel signal. Takes the
signal after the EQ but before the Level control (so you can
check the signal before adding it to Mix or Record)