Black & Decker Spacemaker CG700 - Manual (Page 4)

6 7
GETTING STARTED
• Remove all packing material, labels and any stickers.
• Remove and save literature.
• Unpack mounting parts and set them aside in a safe place where they will not
roll away or get lost.
Important: Do not attempt to operate appliance until it is properly installed.
CHOOSE A LOCATION
When choosing your location, consider the following:
•
DO make sure to mount within reach of an electrical outlet.
• DO consider your normal work patterns in the kitchen when choosing location.
• DO NOT mount over any heating or cooking appliance such as your range or
oven.
• DO NOT mount over or near a sink.
• DO NOT mount under, in front of or behind any under-cabinet light fixtures.
Note: If mounting multiple †SpaceMaker™ appliances and you are installing your
appliance next to the SpaceMaker™ oven (Fig. A.):
• Allow at least 1” between the control panel side of the oven and the appliance.
• Allow at least 4” between the side opposite the control panel of your oven and
adjacent wall or other appliance. You can mount the other appliances flush to
one another.
† . Mounting Parts
(Part # SDC-MOUNTING KIT)
A. 6 Spacers
 ½"
 ¼"
  / 6 "
  / 6"
B.  Screws
 "
 ½"
 ¼"
C.  Washers
. Mounting Template (in box)
You will also need:
• Tape
• Ruler (or you may cut out the ruler provided on the template)
• Electric drill with a ¼” drill bit
A
A
C
B
A.
4” 1”
4”
1”