AMMCO 40111 Environmental Lathe Enclosure Conversion Kit - Manual (Page 11)

Important: Always read and follow operating instructions. • 11
Attach Hood Switch To Enclosure
Attach switch to “L” bracket and align with “Z” bracket.
Drill two 0.203-inch diameter holes thru the enclosure
base. Attach bracket to base.
Use washers, if needed, under switch bracket to align
the switch halves. Route cable along the rear of the
enclosure to the control box. Secure cable with cable
ties and adhesive mounting pads as required.
8. Use the provided cable ties and attachment pads
as needed to fasten the wires.
9. Plug in and check operation of each switch; raising
the hood, pushing the round red E-stop button, pushing
the square stop button, or taking your foot off of the
pedal switch should stop the brake lathe.