Bosch B20CS5 - Manual (Page 23)

24
Electrical connection
Do not use any extension cables
or distributors. This appliance
must be connected to a
permanently installed socket.
Check on the rating plate whether
the indicated voltage and current
type correspond to the values of
your mains supply. The rating
plate is situated in the bottom
leftĆhand side of the appliance.
The power cord may be replaced
by an electrician only.
The socket to which the appliance is
connected must be easily
accessible.
Important!
When installing or changing the
power cord, attach a cord grip.
Checking the water
connection for leaks
q Switch on the appliance
according to the enclosed
operating instructions.
q Remove water according to the
operating instructions. This will
last several seconds as there is
still air in the lines and water
tank.
q Check all screwĆon water
connections for leaks on the
appliance and on the water
connection.
q After checking for leaks, pull out
the main plug again and attach
the motor compartment cover.
Aligning the appliance
To ensure that the appliance
functions correctly, it must be set
level with a spirit level.
If the appliance is not level, water
may flow out of the ice maker, ice
cubes may be irregular or the doors
may not close properly.
q Place the appliance in the
designated location.
q Attach the enclosed base panel
with 3 screws.
q To prevent the appliance from
rolling away, screw down the
front feet until they are
positioned firmly on the floor.
q Rotate the feet until the
appliance is aligned exactly. Use
the doors as a reference point!
- Freezer compartment door is
deeper:
- Refrigerator compartment door
is deeper:
If the previous steps for aligning
the door are not adequate:
q Remove the base panel.
q Loosen 3 hinge screws.
Do not completely unscrew
the screws!
q Place the wrench on the
adjusting screw:
- To raise a door:
Rotate the wrench clockwise.
- To lower a door:
Rotate the wrench
counterĆclockwise.