AMMCO ADAPTEK Adapter Sets, 9310, 9311, 9312, 9313 User Manual
Page 2
4.
Fill out the arbor with spacers as required to
secure entire rotor assembly to the arbor.
NOTE: On AMMCO lathes, the last item placed
on the arbor before the arbor nut must be the
self-aligning spacer.
5.
Tighten the arbor nut by either rotating the rotor
while holding the arbor nut until they lock up, or
by using a wrench to turn the nut until the rotor
begins to turn and then continuing to advance
the wrench
Z
\
z
n
of a turn. Do not overtighten.
Mounting Drums and Flywheels
For drums and flywheels, refer to Figure 1. Use the
same techniques as described in Typical Adapter
Usage for Rotors.
NOTE: When mounting drums, use the largest
flange plate possible inside the drum. The flange
plate must be as large as possible but still allow
clearance for the boring bar. On smaller drums, use
the 29573 Reversible Centering Cone as the inside
flange plate to allow for proper boring bar clearance.
Always refer to your lathe operating instructions for
additional information and procedures about
reconditioning rotors, drums and flywheels.
Parts List
Set No.
Part
Auto & Truck
Auto
Lt. Truck
Truck
No.
For
Description
9310
9311
9312
9313
29572
Auto
Hubless Rotor Flange Plate
1
1
29573
Auto
Reversible Centering Cone
1
1
29574
Auto/Trk
Spacer
2
2
29575
Auto
Composite Flange Plate
1
1
29576
Trk
Large Lt. Truck Flange Plate
1
29577
Trk
Large Lt. Truck Flange Plate
1
29578
Trk
Composite Flange Plate
1
1
29579
Auto
Centering Cone
1
1
29580
Auto
Centering Cone
1
1
29581
Auto
Centering Cone
1
1
29582
Auto
Centering Cone
1
1
29583
Auto
Centering Cone
1
1
29584
Trk
Centering Cone
1
1
29585
Trk
Centering Cone
1
1
29586
Trk
Centering Cone
1
29587
Trk
Centering Cone
1
29588
Trk
Centering Cone
1
29589
Trk
Centering Cone
1
29590
Trk
Centering Cone
1
29591
Auto/Trk
Spring
1
1
1
29727
Trk
Centering Cone
1
929632 01 08/02
© COPYRIGHT 1994 HENNESSY INDUSTRIES AND AMMCO TOOLS ALL RIGHTS RESERVED PRINTED IN U.S.A.