Anchor EVENT AND VENUE LINER - Manual (Page 4)

4
Step 5 - For Event
Eave cables with turnbuckles are required for liner installation. Slide the Liner Eave Bracket onto the interior side of the
upright. Fasten by tightening screw and eyebolt into upright channels as shown below. Attach quick link and cables as
shown in Figure 5b. See Figure 5c for Gable End Cable attachment. Twist Turnbuckles until cables are taut.
Gable End Cable & Mid
Liner Cable fasten into
same eyebolt on Liner
Eave Bracket.
Butt Liner Eave
Bracket up against
purlin bracket.
Upright
Eave
Purlin
Gable End Purlin
Rafter
Figure 5c
Liner Eave Bracket
Figure 5a
Liner Eave Bracket
Figure 5b
Quick link
Mid Liner Cable
(2) Eyebolts and (1) screw are included
with each bracket. Use two eyebolts
where cables are required in adjacent
bays.
Rafter
Eave
Purlin
Mid Liner Cable
Gable End Liner Cable
Upright
Gable End Fabric
Quick Link
Turnbuckle
Turnbuckle
Gable End Liner Cable
Mid Liner Cable
Figure 5d