Anchor NAVI-TRAC LITE 20 WIDE - Manual (Page 13)

INSTALLING THE MID PANELS
To install the mid panel, first attach Fabric Guide Brackets to both beams of the middle bay with the guide wheel assemblies of the two
brackets facing toward each other (fig. 37).
Throw the snap ends of (2) pull ropes up and over the frame from one side of the tent to the other, so that the snaps hang near the
Fabric Guide Brackets.
Feed the leading edge of each Middle Panel kedar through the gap in the guide wheels on each side of the Middle Panel and snap the
pull ropes to the pull web (See diagram at bottom of previous page and fig. 37 & 38). As the panel is pulled, the kedar will feed itself if
the fabric bundle is free of tangles (fig. 39).
13
KEDAR CAPTURED IN
WHEELED GUIDES CLOSE UP OF
GUIDE BRACKETS
PULLING KEDARS
THROUGH CHANNELS
37 38 39