Autoquip HORIZONTAL BALL SCREW - Manual (Page 14)

FLOOR INSTALLATION
1. Make sure installation area is clean before starting.
2. If the permanent electrical work is not complete, some means of temporary lines with
an on-off device for the power supply should be set up for testing purposes.
3. Place the lift in the installation area.
CAUTION!
When moving the lift do not attempt to pick it up by the platform; it is
hinged and could be damaged. Pick up from under the base frame ONLY.
4. Make temporary electrical connections. Raise the lift to the top of its travel and
make positioning adjustments. Check for the proper height. If needed, shim to the
desired height.
WARNING!
Block scissors mechanism in the raised position prior to working under lift.
See the “Lift Blocking Instructions” section.
5. If the decision is made to lag the lift to the floor, the base frame of the lift has pre-
drilled holes for lagging the lift. Mark the holes, drill, and install with anchors.
6. Make permanent electrical connections and operate the lift through a few cycles.
7. Clean up any debris from the area. A clean installation makes a good impression
and creates a much safer environment!
WARNING!
All DANGER, WARNING, and CAUTION labels and informational decals and
plates must be intact and in place on the lift. Contact an Autoquip
representative if labels are missing or damaged. See the “Label
Identification” section.
INSTALLATION INSTRUCTIONS
14