Axcess Network Receiver Installation Guide - Manual (Page 46)

Network Receiver
46 750.001.005 R04 © 2005 AXCESS Inc.
Checking Memory Status
There are commands that provide a means of monitoring memory
status:
df Displays the amount of free RAM
stats Displays the current system status information
(including free memory).
gc Runs the system garbage collector to sweep up and
make available collectible memory. This command
only cleans up garbage generated by slush and not
garbage generated by other applications.
Manually Erasing the Log File (requires Admin authority)
1. Start the Watchdog by entering the command:
wd –p 6000 –i 8000
2. Get the process ID number by entering the command:
ps
3. Kill the process by entering:
kill [process id number]
4. Erase the axcess.log file by typing:
rm axcess.log
5. Reboot the Tini by entering:
reboot
The application software will automatically create a new log file upon
boot-up that will again be at its minimal size.
Note: The following pages give additional command information as
supplied by the provider of the Unix TM -like interface with Serial
(TTY), Telnet, and FTP servers.
Note: The following activity may require Administrator authority. It will
also be necessary access a specific Network Receiver from the DOS
prompt using telnet. For example:
C:\telnet XXX.XXX.XXX.XXX (IP address)
Then at the logon screen, log on to the Tini as previously described.