BKI DR-34 Double Revolving Oven - Manual (Page 10)

Double Revolving Oven Operation
8
“HOLD”, actual oven temperature and hold elapsed time. The control will stay in the hold
mode until the “START/STOP” button is pressed again.
Reviewing Set Points
During the cooking cycle any programmed cooking parameter can be displayed.
1. Press the “SELECT” button until the desired parameter light turns on. The display will show the
value of the set point for five (5) seconds.
2. Reviewing set points during a cooking cycle will not alter them or interrupt the cooking cycle.
Changing Set Points During Cooking
1. Push the “START/STOP” momentarily. The “CYCLE ON” light will flash and the control will go
into pause. In this mode the control regulates at the pre-set points but the cook count down timer
will stop.
2. Change the cooking parameters by pressing the “SELECT” button until the desired indicator light
turns on. The display will show the pre-set value.
3. Press the “UP” and “DOWN” buttons to change the setting as desired.
4. Resume the cooking cycle by press the “START/STOP” button. The “CYCLE ON” light will come
on indicating that the cooking cycle has resumed.
Canceling the Cooking Cycle
Press and hold the “START/STOP” button until the “CYCLE ON” light turns off. (“STOP” will be
displayed).
Power Failure During The Cooking Cycle
The control will suspend operation retaining set points and cycle times. When power is restored,
operation will resume where left off when the power failed.
Probe (Thermocouple) Diagnostics
If the probe (thermocouple inside the oven) stops working, the control will cancel the cooking cycle and
the display will show “PROB”.
If the probe temperature goes below 50° F (10° C.) or, if the control fails, the display will show “EEEE”
and the control will go into “STOP” mode.