Online manual not for resale purposes – BLITZ Scion xB-xA Compressor System User Manual

Page 15

Advertising

30. Zip ties
Ｌ

①

Flange bolt

②

Flange bolt

2. Cover

⑧Hex bolt
⑮Washer

10. Trans. bracket

①Bolt
⑫Nut

11. Dip stick
bracket

Original dip
Stick bracket

25. Using #11 bracket, attach one end to #9
bracket (this is the bracket holding the
compressor and the intake manifold) and the
other end to the genuine dip stick brakcet.
Use

①

bolt (1) and

⑫

nut (1) to attach

genuine dip stick and # 11 bracket.

*note: make sure everything is secure and tighten

down.

26. Using #30 zip ties, tie down the harness
to the fuel rail.

27. Install compressor cover. Use the #5
Compressor gasket,

①

bolt (4), and

②

bolt

(2).

*note: make sure not to over tighten

①

Flange

bolt(s).

28. Using #10 bracket, attach to transmission
as shown, using the

⑧

bolt (1), and the

⑮

washer (1). *Do not secure the bracket yet.

Online Manual Not For Resale Purposes

Advertising