Bushnell 26-04002.5x42 User Manual

Page 5

Advertising
background image

7

• Do not point this device toward any light source greater than 1 lux

such as car headlights, for an extended period of time.

• This device utilizes an internal flash protection system which

minimizes potential damage, but long-term exposure to bright
lights can damage the unit. Any such damage may void
your warranty.

• This device was designed to be self-contained. Do not open the

body of the device or otherwise attempt to service this device.

• Always store the device in a dry, well-ventilated room.

• Remove the batteries if the device is to be stored for longer

than 2 months.

• Keep the device away from any heating and air conditioning vents

or other heating devices, direct sunlight, and moisture.

• Avoid dropping or otherwise shocking the unit. Although designed

for rugged outdoor use, this device incorporates a sophisticated
optical system, which could be damaged in extreme cases of misuse.

• Clean the optical lenses with professional lens cleaning supplies.

• Clean the exterior of the device with a soft clean cloth.

Class 1 LED product per IEC 60825-1/nov 1993, appendix EN 60825-
1A11/oct1996

8

Caution: This device can be used in extreme cold weather. However, when the unit is brought back into a warm environment,
you must wait approximately 5 hours before using the unit again. Damage may occur due to condensation that may have
accumulated on the internal circuitry of the unit.

Spots In The Image

You may see spots in the image. These vary from device to device and are cosmetic blemishes inside the device. These are
normal for Night Vision devices and are NOT a defect.

TROUBLESHOOTING

Scope will not turn on.

Check that the batteries are installed properly. Replace the batteries with new ones. Check the battery contacts to ensure they
are clean and free of corrosion. Check that the power is in the “ON” position.

Image is not focused.

Adjust the focus on the Eyepieces. Adjust the Objective Lenses. If still no improvement, clean the lenses; they may be
foggy or dusty.

Visibility decreases or disappears.

Bright light sources such as headlights may cause visibility to degrade or disappear completely. Turn the Power OFF and turn
the scope away from the light source. The unit will restore itself in 1 or 2 minutes. Conditions such as fog or extremely dark
environments will decrease visibility.

Scope flashes.

The scope may flash when used in a bright environment. It may also flash during the first few seconds of use
in dark environments.

CARE AND MAINTENANCE

Your Bushnell Night Vision device was designed to provide many years of reliable service. To ensure that you get the most
enjoyment out of your Night Vision device, always obey the following warning and precautions:

TWO-YEAR LIMITED WARRANTY

Your Bushnell

®

product is warranted to be free of defects in

materials and workmanship for two years after the date of
purchase. In the event of a defect under this warranty, we will, at
our option, repair or replace the product, provided that you
return the product postage prepaid. This warranty does not cover
damages caused by misuse, improper handling, installation, or
maintenanc e provided by someone other than a Bushnell
Authorized Service Department.

Any return made under this warranty

must be accompanied by the items listed below:

1)A check/money order in the amount of $10.00 to cover the

cost of postage and handling

2)Name and address for product return
3)An explanation of the defect
4)Proof of Date Purchased
5)Product should be well packed in a sturdy outside shipping

carton, to prevent damage in transit, with return postage
prepaid to the address listed below:

IN U.S.A. SEND TO:

IN CANADA SEND TO:

Bushnell Performance Optics

Bushnell Performance Optics

Attn.: Repairs

Attn.: Repairs

8500 Marshall Drive

25A East Pearce Street, Unit 1

Lenexa, Kansas 66214

Richmond Hill, Ontario L4B 2M9

For products purchased outside the United States or Canada please

contact your local dealer for applicable warranty information.

In Europe you may also contact Bushnell at: 33 141 44 94 80

Bushnell Performance Optics
Germany GmbH
Morsestrasse 4
50769 - Cologne
Germany

This warranty gives you specific legal rights.

You may have other rights which vary from country to country.

©2002 Bushnell Corporation

Advertising