Cambridge SoundWorks BassCube 10S Powered Subwoofers - Manual (Page 7)

7 7 7
5. OUT TO SPEAKERS
Connect your left and right speakers to these outputs
if you use the SPEAKER LEVEL INPUTS .
6. POWER indicator
Glows green during normal operation. Glows red in
standby mode.
7. LOW PASS FREQUENCY
When you connect a BassCube to the Subwoofer Out
of a 5.1 channel Dolby Digital ® or DTS ® audio system,
set this control at its full clockwise rotation. If you con-
nect a BassCube with speaker wires, or to the
Subwoofer Out of a stereo receiver, adjust this control
higher for small main speakers and lower for large
main speakers (see page 13).
8. PHASE (BassCube 10S only)
The main speakers and the subwoofer may cancel
each other out across the small range of frequencies
where they overlap. This control will counteract this
effect.
SUBWOOFER
LEVEL
LOW PASS
FREQUENCY (Hz)
R
MONO
L
LINE
LEVEL
INPUTS
R L
SPEAKER LEVEL INPUTS
+ +
OUT TO SPEAKERS
5
4
3
2
1
0
6
7
8
9
10
OFF ON
AUTO
0˚ 180˚
PHASE
75
85 120
140
R L + +
100
POWER
RED – STANDBY
GREEN – ON
*
* SET LOW PASS FREQ HERE
WHEN USING 5.1 CHANNEL
HOME THEATER SUB OUT
BassCube 10S Back Panel Diagram
4 1 2 3
5
6
8
7