Cambridge SoundWorks The Outdoor Speakers by Henry Kloss - Manual (Page 5)

4
The Outdoor In-Wall
Installation
Mounting
The Outdoor In-Wall speaker is
designed for easy installation in walls
constructed of drywall, paneling, etc. of
up to 1
1 / 4 " thickness.
1. When choosing installation sites, be
sure to take into account such factors
as wall studs, and plumbing or
wiring within the wall.
2. Use the enclosed mounting template
as a guide to scribe the outside
dimensions of the cut-out you need
to make on the wall. It’s a good idea
to use a level or other method to
“square” the cut-out to the room.
While the level of the speaker itself
may be adjusted slightly within the
hole after it has been cut, it is best to
start with a properly leveled cut-out.
3. Depending on the wall’s construc-
tion, use a utility knife and/or key-
hole saw to cut out the mounting
hole. If you are cutting into material
that has a skim coat of plaster, it’s a
good idea to drill a hole at each
corner of the cut-out first to
prevent cracking.
4. Connect the speaker wire to the
speaker as described in the preceding
section, then push the unit into the
cut-out. Use a level or other means to
square it properly, and step back to
verify that it also
looks level.
5. Tighten the four black Phillips
head screws clockwise, which
causes the speaker’s unique
mounting swing-arms to extend
and grip the wall material from
the inside.
Do not overtighten the
mounting screws; excessive force
can crack some materials, such as
drywall.
6. Install the speaker grille.
The Outdoor speaker in free-standing
cabinet features a molded socket on
the rear of the cabinet for attaching a
mounting bracket (Vogel swivel
bracket #A1SAT5WH is recom-
mended, available from Cambridge
SoundWorks). Also, a keyhole slot
makes it possible to simply hang the
speaker on a screw or nail
(see diagram on right).
DISCLAIMER: Installing a speaker
in a wall requires knowledge of the
wall’s construction and any
components, wiring or other
obstacles that may be enclosed
within the wall. Proper installation
of
The Outdoor In-Wall loudspeaker
is soley the responsibility of the
speaker owner and/or installer.
Cambridge SoundWorks cannot be
held responsible for any matters
relating to the actual installation of
the loudspeaker.
B Y H E N R Y K L O S S
T HE O UTDOOR
MADE IN CHINA
8 OHMS
DESIGNED BY CAMBRIDGE SOUNDWORKS, INC.
NEWTON, MASSACHUSETTS USA 1-800-367-4434 USA 617-332-5936 (OUTSIDE USA)
B Y H E N R Y K L O S S
T HE O UTDOOR
MADE IN CHINA
8 OHMS
DESIGNED BY CAMBRIDGE SOUNDWORKS, INC.
NEWTON, MASSACHUSETTS USA 1-800-367-4434 USA 617-332-5936 (OUTSIDE USA)