Cambridge SoundWorks MovieWorks HD - Manual (Page 14)

Using Your MovieWorks HD 13
Turning on MovieWorks HD or enabling Standby mode
Press the Power/Standby button on your remote control to turn on
MovieWorks HD or enable Standby mode. For Power/Standby LED
information, see “Understanding the Power/Standby LED” below.
Returning to factory default settings
While you connect the power jack or plug the power adapter to the power
outlet, press and hold the Power button on your MovieWorks HD until the
Power LED changes from red to white and remains lighted up in white.
During a reset, MovieWorks HD reverts to the original volume setting, and
turns on the X-Fi enhancements to default levels. If your MovieWorks HD is
paired with any Creative Wireless Receiver, the zone control settings are
also erased.
Understanding the Power/Standby LED
NOTE You can also press the Power/Standby button/LED on MovieWorks
HD.
LED Behavior Status
White Stable Turned on and ready for use
Red Stable In Standby mode
Stable (Red) -> Stable (White) Establishing wireless connection
Quick flashing (twice) Receiving remote control signals
Continuous slow flashing Muted
NOTE For information on the Link LED, see the Creative Wireless
Receiver User’s Guide.