Caron GASG201 - Manual (Page 9)

Model GASG201 Operations Manual Page 9 of 13
Rev D 01/18/2009
Connect model GASG201 to a grounded circuit.
Failure to do so could result in electrical shock.
Tank 1
Gas Inlet
Tank 2
Gas Inlet
Gas Out
to Device
Power Cord /
Fuse Holder
Once the cylinder regulators are installed and adjusted on each tank, connect the outlet
of the regulator on Tank 1 to the hose barb fitting labeled Tank 1 on the back of the unit
using the tubing and clamps provided. Repeat the process for Tank 2. The gas outlet
connection on the back of the unit can then be connected to the incubator using the
supplied tubing and clamps. Turn on the regulated gas supplies and check the
connections closely for leaks.
Connecting Electrical Power
Model GASG201-1 requires a standard 115VAC, 15A power connection. The power
cord connection is a NEMA 5-15P plug. Model GASG201-4 requires a standard 230VAC
power connection. The power cord connection is a NEMA 6-15P plug. When the
required electrical connection is available, plug the provided power cord into the unit and
the appropriate electrical outlet.
Equipment Operation
The power switch is used to turn on/off the operation of the product. If power is off, the
unit will allow gas to flow through Tank 1 if required by the incubator.