CiDRA Elevated Temperature Sensor Head - Manual (Page 19)

WARNING
Discharge each sensor per user manual instructions just prior to
connecting sensors to preamp. Failure to do so may result in
damage to preamp!!
Starting with sensor #1, discharge that sensor by attaching it to the
sensor shorting plug. Insert the sensor connector into the mating
connector (connector #1) mounted on the bottom of the preamplifier
module. Repeat for the remaining 9 wires. Note: It may be easier to
connect the sensors by first removing the connector block and then re-
installing the block after all connections have been made.
Turn the pre-amplifier over.
Re-install the four pre-amplifier mounting screws.
Connect the wire interconnect wire connector to the pre-amplifier.
Interconnect
wire connector
Figure 17 Wired and Mounted Pre-amplifier
Ensure the grounding wire is attached to the pre-amplifier cover
Install the preamplifier cover and install the four cover screws.
21020-01 Rev 01 Page 2-15