COATS Kit 1.125-inch, Kit 40 mm, XL Pressure Drum - Manual

8113306 01 3/02 © COPYRIGHT 2001 ALL RIGHTS RESERVED PRINTED IN U.S.A.
1.125 inch Kit
40 mm Kit
Description
• Special rubber lip for wheel protection.
• Designed for alloy wheels that are not compatible
with standard pressure cups.
• Used in back cone mounting procedures.
Back Cone Mounting Procedure
1. Slide backing spring and appropriate size back
cone on balancer shaft.
2. Seat wheel on back cone making sure the
wheel doesn’t slip off the cone.
3. Slide XL Pressure Drum on the shaft with the
special protective rubber lip facing the wheel.
4. Finish mounting by threading the hub nut on the
shaft clockwise until handtight.
Handtighten and
you are ready to
balance.
Back Cone
(not included)
Hub Nut
(Quick Release Slide
Nut not included)
XL Pressure Drum
with Rubber Lip
XL Pressure Drum