Condux Crimp-On Pulling Eyes - Manual (Page 10)

E. CRIMPER DIE SELECTION
Now that the pulling eye is on the cable, you must get the crimper ram ready to crimp on
the pulling eye. Go to the chart below and select the proper crimper die for the size
pulling eye you will be using. Take the die and snap it into the end of the ram on the
crimper assembly.
F. CRIMPER CABLE SELECTION
From the chart, locate the proper crimper cable based on the pulling eye inside diameter.
Pulling Eye Pulling Eye
Inside Diameter Inside Diameter Crimper Crimper Crimper Crimper
(in.) (in.) (mm) (mm) D i e D i e Cable Cable
0.950 24 08920011 08920002
Loosen the setscrew in the retaining ring and pull it down away from the base.
G. ATTACHING THE CRIMPER CABLE
10