Control Company 5095 COUNTDOWN CONTROLLER - Manual (Page 2)

AUTO-RETURN TO CLOCK DISPLAY
If the unit is left idling more than 1 minute during
programming or displaying another mode, the display
will return to clock and the programming operation is
cancelled. However, if the display is showing count down
time in progress, auto-return will riot activate until count
down is finished.
LED INDICATOR
The LED indicator shows the status of the timer. If the
LED is lit, the timer is on and if the LED is not lit, the timer
is off. Note that the timer’s status can also be seen in the
CLOCK mode, by the word ON or OFF. The LED will only
light when the timer is plugged into an electrical outlet.
RESET
The RESET key is located on the top-right hand corner
of the function board. Use a round object such as a
ball-point pen to push the reset key while the SET key
is pressed. Then release the RESET key first before the
SET key. After reset, all preset programs are erased from
timer’s memories.
ABNORMAL DISPLAY
When an abnormal display or a blank display appears on
the timer, use the above Reset procedure, otherwise the
timer may not work properly. Be sure that the recharge-
able battery Is adequately charged.
WARRANTY, SERVICE, OR
RECALIBRATION
For warranty, service, or recalibration, contact:
CONTROL COMPANY
4455 Rex Road
Friendswood, Texas 77546 USA
Ph. 281 482-1714
Fax 281 482-9448
E-mail [email protected]
www.control3.com
Control Company is ISO 9001
Quality-Certified by DNV and
ISO 17025 accredited as a
Calibration Laboratory by A2LA.
TRACEABLE
COUNTDOWN
CONTROLLER
INSTRUCTIONS
®
©2014 Control Company . 92-5095-00 Rev. 3 060214
Traceable
®
is a registered trademark of Control Company.