Control Company 3326 LABTOOL II & MINI-LABTOOL - Manual

Traceable ® is a registered trademark of Control Company ©2009 Control Company. 92-3326-00 Rev. 1 031609
LABTOOL II™
(Control Cat. No. 3326)
SPECIFICATIONS
Size: 3⅝” (when closed)
Tools:
A Pliers
B Grippers
C Wire Cutter/Wire Stripper
D Safety Knife Blade
E Phillips
™ Screwdriver
F Large Flathead Screwdriver
G Ruler/Serrated Stripper
H Saw
I Knife Blade
J Bottle Opener/Medium Flathead Screwdriver
K Needle
L Punch/Small Flathead Screwdriver
M Serrated Knife Blade
MINI-LABTOOL™
(Control Cat. No. 3327)
SPECIFICATIONS
Size: 2⅝” (when closed)
Tools:
A Pliers
B Grippers
C Wire Cutter/Wire Stripper
D Key Ring/Key Chain
E File
F Flathead Screwdriver
G Bottle Opener
H Serrated Knife/Saw Blade
I Knife Blade
J Phillips
™ Screwdriver
K Scissors
L Can Opener
SAFETY
All tools are extremely sharp. Handle with caution when opening, closing,
and operating individual tools.
Open only one tool at a time.
Close all other tools and blade components before operating the pliers or
grippers.
Always use caution and keep fingers clear when closing components into the
handles.
When wire cutting and/or using the pliers and grippers, keep fingers
and hands clear of approaching handles to avoid getting pinched.
Always wear eye protection when cutting wire.
The handles and tools are initially stiff to
operate, but become more flexible with use.
OPERATION
Pliers / Grippers
1. Unfold by pulling the handles apart.
2. Continue to unfold the handles until the pliers are completely
visible.
3. Squeeze the handles together to use as pliers or grippers.
Wire Cutters / Wire Strippers
1. Unfold by pulling the handles apart.
2. Continue to unfold the handles until the pliers are completely
visible.
3. Insert the wire to be cut at the base of the pliers and squeeze
the handles together.
To use as a wire stripped, apply only enough pressure to cut
through the insulation. Once the insulation has been cut from
around the wire, use the pliers to pull the cut insulation off of the
wire.
Handle Tools
1. Carefully pull the desired tool out of the handle compartment.
2. Fully extend the desired tool until a click is heard.
3. To store the tool, simply fold it back into the handle.
WARRANTY, SERVICE, OR RECALIBRATION
For warranty, service, or recalibration, contact:
CONTROL COMPANY
4455 Rex Road
Friendswood, Texas 77546 USA
Ph. 281-482-1714
Fax 281-482-9448
E-mail [email protected]
www.control3.com
Control Company is ISO 9001
Quality-Certified by DNV and ISO
17025 accredited as a Calibration
Laboratory by A2LA.
LABTOOL II™ & MINI-LABTOOL™ INSTRUCTIONS