Bissell ProHeat 7950 - Manual (Page 20)

Powerdrive does not seem to be engaged.
Possible Causes Remedies
The Powerdrive is in the OFF position Turn the Powerdrive Knob to the “ON” Position
Handle not fully engaged with Powerdrive position Push handle in as far as it will go to feel the
most impact
SmartTemp Ready Light does not illuminate.
Possible Causes Remedies
The SmartTemp Switch is not turned ON ( I ) Turn on the SmartTemp Switch
The machine Power Switch is not Both switches must be ON ( I ) to
turned ON ( I ). activate the SmartTemp Ready Light.
Reduced spray or no spray.
Possible Cause Remedies
Bladder may be empty. Refill Bladder with hot tap water.
SmartMix Tank may be empty. Fill with BISSELL deep cleaning formula
for cleaning or water if
rinsing,or using the Scotchgard
protector applicator.
The filter may be clogged. Clean out Flow Indicator Filter, page 17.
Tanks may not be seated properly. Turn power OFF; remove & reseat
tanks. Inspect for presence of seals.
Pump may have lost prime. Turn power OFF; after 1 minute turn
ON and depress Trigger.
The Pump Belt may be broken. Turn the machine OFF and unplug
from the outlet. To check if a Pump
Belt has broken, you will need a flat
head screwdriver. Insert the blade end
into the lower slot of the Belt Access
door to release the lower snap. If
necessary, insert the blade end into
the upper slot to release the upper
snap. Examine the belt for breakage.
You should be able to see the Pump
Belt looped around the motor shaft. If
it is broken or missing, please refer to
Replacement Parts on page.23 before
calling Consumer Services. Complete
installation instructions will
accompany the replacement belt.
20
WARNING:
To reduce the risk of
fire, electric shock or
injury unplug from outlet
before servicing.
Troubleshooting
Insert
Screwdriver
Blade Here
Lift Here
1 1
1 1
2 2
2 2
1 1
2 2
3 3
4 4
5 5
6 6