Caution, Warning, Step 4. load – Daisy AVANTI Elite 753 User Manual

Page 4: Step 5. close bolt, Step 6. aim at safe target, Step 7. take “off” trigger safety

Advertising
background image

CAUTION:

Be sure to grasp pump handle firmly as you close the lever to prevent it from

snapping back and causing possible injury. Also be careful to keep fingers out of cocking

mechanism when closing lever. (See “PINCH POINTS,” Drawing No. 2).

WARNING:

Do not open the bolt, close the bolt, and then pull the trigger before

pumping. This procedure can result in a

loaded gun and a projectile being expelled from the

gun during pumping. Recock the gun by opening the bolt and put “ON” trigger safety before

pumping as in Steps 1 and 2.

CAUTION:

If gun is left unpumped for an extended period of time OR pumped more than

once, all of the air may not be expelled when the gun is shot. This could result in a second

pellet being shot without the gun having been pumped. Also, leaving your gun pumped for

more than one hour could result in damage to your gun.

Step 4. LOAD

LOADING PELLETS: With the bolt back, lower the

muzzle slightly and load a pellet, solid end forward

(See Drawing No. 3).

Step 5. CLOSE BOLT

Push the bolt handle fully forward. This will chamber

a pellet and lock the bolt. (See Drawing No. 4) The gun

will not fire if the bolt is open.

CAUTION:

The gun is now loaded

and ready to fire.

Step 6. AIM AT SAFE TARGET

Aim the gun at a safe target. To be a consistent

marksman, use the correct sight picture each time

you fire your gun (See Drawing No. 5).

Never point a

gun, loaded or unloaded, at anyone.

CAUTION:

Use extra caution in selecting a

safe target and backstop. This gun should not

be used with BB gun targets or backstops. Whether

you use a commercial target and backstop or make

your own, it is important to remember that they will

wear out with continued use. Because of this you

should always place your target and backstop where

it will be safe should it fail, and check it carefully

before and after each use. Do not shoot at the surface

of wate

r.

Step 7. TAKE “OFF” TRIGGER SAFETY

When you are certain the target, backstop and

surrounding area is safe, push the trigger safety from

the right, fully to the left (RED SHOWING ON LEFT).

Your gun is now cocked and ready to shoot. In this

condition, it should be handled with extreme care.

4

NO. 3

FEED TRACK

PELLET

(SOLID

END FORWARD)

NO. 5

BULLSEYE

FRONT SIGHT

REAR SIGHT

NO. 4

Advertising